Car Builders Van Liner Closed Cell Foam 1m x 5m

Car Builders Van Liner is a 10mm thick, lightweight thermal/acoustic barrier, designed to insulate the inside of vehicles. It is Stage 2 insulation to be applied on top of our Stage 1 Sound Deadener on single-layer sheet metal. 

Car Builders Van Liner will not rot, attract moisture or mould and it is easy to cut. 

NOTE: For all inverted applications, such as roof skins, it is recommended to apply our upholstery grade Spray Adhesive, rate at 120°C. 

Features/Advantages:

• Lightweight
• Easy installation - just peel off the release liner and adhere to the surface
• Cuts with scissors or knife
• Only 10mm thick - outperforms much thicker insulation on the market
• Silver PET face further prevents any heat from being emitted into the vehicle
• Does not rot or deteriorate

Applications:

• Van walls
• Roof skins
• Fender cavities 
• 1/4 panels
• Doors
• Campers, trucks, various equipment

Is there a Stage 3 product to go over Van Liner and do I need it? 

This is recommended if you are converting your van to a camper with internal walls (plywood, MDF etc). Car BuildersStage 3 product is called Van Seal. It is a 4mm thick closed-cell foam with a reflective face on both sides. It is used to create a sealed inner cocoon in your van, forming a very effective insulation barrier, further slowing heat conduction and convection. Simply line the side walls and roof with Van Seal before applying your structural panels e.g. plywood. Ensure there is an air gap between the Van Liner (stage 2) and Van Seal (stage 3).